Simultaneous Encode & Decode for MINI & STUDIO (FW. 3.0)
There is a beta feature in FW 3.0 that allows a BD STUDIO or MINI to encode and decode at the same time, two different NDI signals. This feature is a BETA feature because of a known issue, where the RX side of the unit (DECODE) drops frames every few seconds. This article will be updated when the feature has been corrected, but at the present time, this feature is not to be considered fully functional and supported.
In firmware 3.1, this beta feature was removed for stability concerns.
Related Articles
Studio NDI User Guide
Link: User Guide
Mini NDI User Guide
Link: User Guide
Mini LED Light Status Definitions
There are three status options for the Mini's LED status lights: 1. Green/Blue - Operational and Working Correctly 2. Green/Green - Operational but no valid Source (decode or encode) 3. Green/Red - Operational but no valid source (encode only)
Updating Firmware for BirdDog Studio NDI
Updating firmware on BirdDog Studio NDI is simple and fast, please follow the following steps to update your device. 1) Log onto the web interface of your BirdDog Studio NDI. To access the web interface of Studio NDI, open your favourite web browser ...
Mini Factory Reset
If you need to perform a factory reset on a BirdDog Mini, follow these directions: ~ power the unit on. ~ After the unit has powered on for a few minutes, press and hold the reset button (on the side) for 5 seconds. ~ Release the button after 5 ...