Mini Factory Reset

Mini Factory Reset

If you need to perform a factory reset on a BirdDog Mini, follow these directions:

~ power the unit on.

~ After the unit has powered on for a few minutes, press and hold the reset button (on the side) for 5 seconds. 

~ Release the button after 5 seconds and let the unit run for another few minutes. 

~ Power cycle the BirdDog Mini. The IP address and settings should be set to factory settings, 192.168.100.100.


Please reach out to us if you need any additional assistance at help@bird-dog.tv



    • Related Articles

    • Mini NDI User Guide

      Link: User Guide

    • Studio-NDI · Factory Image Process (REV4)

      The following is the complete factory re-image process. This process should fix: Studio devices that are "Stuck on Startup"  Startup and get stuck on the "IP scroll" during bootup  WebUI menu screens are corrupt and not displaying correctly.  Please ...

    • Mini LED Light Status Definitions

      There are three status options for the Mini's LED status lights: 1. Green/Blue - Operational and Working Correctly 2. Green/Green - Operational but no valid Source (decode or encode) 3. Green/Red - Operational but no valid source (encode only)

    • 4KHDMI Factory Reset Button

      The following can help you recover the 4KHDMI device if the unit is on the latest firmware: Reset Network to DHCP on Device ~ press and hold for 20+ secs. - reverts back to DHCP on a selected NIC Reset Network to DHCP and Device Interface back to ETH ...

    • 4KQUAD Factory Reset Button

      The following can help you recover the 4KQUAD device if the unit is on the latest firmware: Reset Network to DHCP on Device ~ press and hold for 20+ secs. - reverts back to DHCP on a selected NIC Reset Network to DHCP and Device Interface back to ETH ...