Why does a connection time out after it has connected and has been running?
The "Connection Timeout" message may also appear if the SRT connection breaks and out endpoints are not able to auto reconnect. Should a connection break, it may be due to a RTT that is too high compared to SRT Latency setting. Please allow for at least 3 x RTT in SRT Latency, on lossy connections even more. Also try to increase the SRT overhead to allow for more bandwidth to resend lost packages.
Related Articles
Connection Subscriptions
Subscriptions BirdDog Cloud is licensed by Subscriptions. This allows access to the platform for a certain number of concurrent connections. For example, each live connection you have between two locations counts as a single connection. You can ...
Troubleshooting "Connection Timeout"
Connection Timeout is usually caused by the fact that the 2 EP cannot create the SRT connection on the selected UDP port. This can be caused either by a firewall configuration problem, or that the UDP port is currently being occupied. A previous ...
No NDI output on a SRT connection
After a connection is created, there is no NDI output or very low frame rate on the RX endpoint. Please try to use NDI Time Stamps as Timecode handling. Low frame rate could also indicate poor hardware performance. If there is no FPS shown on the RX ...
Cloud Connect problems
Here are some common issues with Cloud Connect (CC) Connections: 1. I get CC from EP connected, but video does not start in app or web player. it looks like possibly your fw is blocking the connection. Please refer to the Network document for BirdDog ...
Why does my enpoints not connect when they did earlier?
When you have used a UDP port on a connection and stops it, it may take some time before the worker is removed and release the port. You can try to use another port, or restart the EP. That should ensure that the port has been released.