BirdDog X1/X1 Ultra VISCA commands

• Related Articles

• X5 Ultra VISCA Commands

  Overview This guide provides an introduction to VISCA commands used to control PTZ (Pan-Tilt-Zoom) cameras. VISCA is a widely used protocol for managing camera functions via serial or IP communication. This document explains how to use these commands ...

• BirdDog MAKI Ultra VISCA commands

  The BirdDog MAKI Ultra 12x and BirdDog MAKI 20x cameras support many controls over multiple protocols. One of the most commonly used protocols is VISCA. VISCA commands can be used either over the serial connection (RS485) on the camera, or over the ...

• BirdDog X1 / X1 Ultra Firmware Release Notes

  Firmware Version 6.1.062 This release includes the following fixes: Fixed an issue where the TELE and WIDE Zoom controls switched in the BirdUI. Fixed an issue where Preset Recall Speed did not match setting selected in BirdUI. Firmware Version ...

• BirdDog X5 Ultra Firmware Release Notes

  Firmware Version 0.3.0030.00 New Features & Improvements: Added the ability to Mute Audio Input in BirdUI. Added a "HOME" icon to the PTZ control interface in the CamControl tab of the BirdUI. Pressing this will recall the camera to its home position ...

• X-Series Camera API

  You can find our API document for the X-Series at the following link: X-Series API* This document supports commands for the following units: X1 X1 Ultra MAX X4 Ultra *Our API can also be found on our website under Products → AV Section → Automation / ...